• In case of flame extinguishing by any reason 12. MAINTENANCE
during working, the security tap will stop the gas • Before carrying out any maintenance operation
flow. close the gas valve and disconnect the electrical
supply.
11. CLEANING • Any part of the machine should not repaired or
• Before beginning to clean, the electricity of the changed by the user.
oven must be switched off. • In case of a dangerous situation about the machine
• Before carrying out any cleaning operation close inform the authorised service.
the gas valve and disconnect the electrical supply.• Do not allow unqualified persons to repair the
• At the end of each working day, before cooling appliance.
down clean it with oil cleaner and soapy water
and then make it dry. 13. PROBABLE PROBLEMS AND SOLUTIONS
• While cleaning the oven surface do not use • If the energy lamp is not on, control the electricity
corrosive detergents and materials that may switch.
scratch the surface like brushes or etc. • If the gas control switch is on the pilot flame
• The holed intervals in the oven can easily be taken position but it does not burn, control the gas
out. Everyday clean them with soapy water, dry valve. If it is turned off, turn it on.
and put them to their places again. • You did every step(heat select, position key,
• According to water quality for every period burning the pilot) to make the oven operate. If the
between 4-6 months, clean the steam jet as to appliance does not operate the door may not be
prevent from use and being limed. closed properly. Control the door to be at the right
• Everyday, after working hours clean the fat and place.
water dispose hole and fat collection pot at the • In spite of everything if the appliance does not
oven floor. operate, the breakdown lamp on the control board
WARNING: Do not clean the appliance with will be on. In this case, inform the authorised
direct or high pressure water not to damage the service and do nothing with the oven.
electrical installation.
EXPIRY TIME IS 10 YEARS.
14