• In case of any breakdown on the oven, the
breakdown lamp number “5” warns the user. 12. MAINTENANCE
• In case of flame extinguishing by any reason • Before carrying out any maintenance operation
during working, the security tap will stop the gas close the gas valve and disconnect the electrical
flow. supply.
• Any part of the machine should not repaired or
11. CLEANING changed by the user.
• Before beginning to clean, the electricity of the • In case of a dangerous situation about the machine
oven must be switched off. inform the authorised service.
• Before carrying out any cleaning operation close • Do not allow unqualified persons to repair the
the gas valve and disconnect the electrical supply. appliance.
• At the end of each working day, before cooling
down clean it with oil cleaner and soapy water 13. PROBABLE PROBLEMS AND SOLUTIONS
and then make it dry. • If the energy lamp is not on, control the electricity
• While cleaning the oven surface do not use switch.
corrosive detergents and materials that may • If the gas control switch is on the pilot flame
scratch the surface like brushes or etc. position but it does not burn, control the gas
• The holed intervals in the oven can easily be taken valve. If it is turned off, turn it on.
out. Everyday clean them with soapy water, dry • You did every step(heat select, position key,
and put them to their places again. burning the pilot) to make the oven operate. If the
• According to water quality for every period appliance does not operate the door may not be
between 4-6 months, clean the steam jet as to closed properly. Control the door to be at the right
prevent from use and being limed. place.
• Everyday, after working hours clean the fat and • In spite of everything if the appliance does not
water dispose hole and fat collection pot at the operate, the breakdown lamp on the control board
oven floor. will be on. In this case, inform the authorised
WARNING: Do not clean the appliance with service and do nothing with the oven.
direct or high pressure water not to damage the
electrical installation.
13