the edge of the work surface, touch You may wish to retain the packaging for
sources of heat or become knotted. future use.
• Do not operate this appliance if the mains
lead or pug are damaged, or if the Box contents
appliance malfunctions or is damaged Kettle
in any way. Check the mains lead Power base with mains cable and plug.
regularly for signs of damage.
• No user-serviceable parts inside – refer User Guide
to qualified service personnel. Position the kettle on a stable flat surface
out of the reach of children and close to
ELECTRICAL SAFETY a mains supply socket.
Make sure that the mains power cable is
WARNING! not placed where it can be inadvertently
Read these safety instructions thoroughly pulled or pinched.
before connecting this product to the
mains supply. Using Your Kettle
NOTE:
Before switch on, make sure that the Before first use, fill with water to the
voltage of your electricity supply is the maximum mark, bring to the boil and
same as that indicated on the rating plate. discard – this will ensure that your kettle
This product is designed to operate at is perfectly clean.
230VAC50Hz. Connecting it to any other
power source may cause damage. Filling
This product may be fitted with a non- WARNINGS!
rewire able plug. If it is necessary to Always remove the kettle from the base
change the fuse in the plug, the fuse before filling. Do not overfill as boiling
cover must be refitted. If the fuse cover water may be ejected from the spout.
becomes lost or damage, the plug must To fill the kettle remove it from the base.
not be used until a suitable replacement Lift the hinged lid. Fill to the desired level
is obtained. between the MIN (0,5 litre) and MAX (1,8
If the plug has to be changed because litre) marks on the gauge. Close the lid
it is not suitable for your socket, or due and place back on the base.
to damage, it should be cut off and a
replacement fitted, following the writing Switching On
instructions shown below. The old plug To switch the kettle on, gently press down
must be disposed of safety, as insertion the On/Off switch. The Power Indicator
into a 13 amp socket could cause an on the handle will light.
electrical hazard.
Switching Off
Preparation for Use When the water has boiled the kettle will
Carefully remove your kettle from the box. switch off automatically. You can stop
9