operating for the first time, there may be 2- Adjust the browning control to achieve
a slight burning odour as the heating the amount of toasting desired.
elements warm up. This represents no 3- Press the Cancel button at any time to
danger to the user and does not indicate stop toasting.
a defect in the appliance. When using for 4- If you should find that the bread is not
the first time, allow the toaster to heat up dark enough you may wish to toast the
until the odour clears. bread again. Turn the browning control
It is advisable to first operate the toaster to a lower setting and keep a careful eye
without bread. on the toaster to ensure that the toasted
1-Connected the toaster to the mains supply does not burn.
and switch on. 5- When toasting has finished the loading
2- Set the browning control to the lowest handle will rapidly rise to the fully raised
setting. position. The toasted bread can now be
3- Press the loading handle down and allow removed and the toaster is ready to
the heating elements to warm. recommence toasting.
4- Allow elements to heat up until burning
odour clears. Controls
5- Press the Cancel button to release Browning Control
loading handle. The browning control varies the time the
bread is toasted. The control can be set
WARNING from 1 to 6, where 1 is the shortest time
Never leave your toaster unattended (lightest toasted) and 6 is the longest
when in use as toast can burn. time (darker toast).
Remember to increase the browning
Toaster Operation control setting for subsequent operations.
WARNING If the toast is too dark, reduce the
Never force bread into the toasting slots. browning control before toasting the next
Bread should fit easily into the toasting slice.
slots. Do not toast buttered slices of Dry or thin slices will toast quicker than
bread. moist or thick slices, so use a lower
1- Place one or two slices of bread in the browning control setting for dry or thin
bread in the toasting slots (one in each slices.
slot) then press the loading the loading When toasting two slices at the same
handle right down until it latches. The time try to use the same size and
bread will be lowered into the toaster and consistency of bread to achieve equal
toasting will begin. browning.
NOTE
The loading handle will not latch if the Cancel Function
unit is not connected to the mains, and If the toast starts to smoke before it has
may not latch if the browning control is popped up, stop the toasting process by
set to minimum. pressing the Cancel button.
9