3. When required, push the desired nozzle ATTENTION:
onto the lower end of the telescopic Only use the cylinder vacuum cleaner
tube or the handle (Fig. 9). if all filters are correctly in place and
once you have ensured that no
openings are blocked The filters must
be intact and dry. Non-compliance can
damage the cylinder vacuum cleaner.
1. Push on the desired nozzle
2. Remove the cable, by holding the plug,
until the yellow mark is reached (Fig.
ATTENTION: 11/1).
If you use the cylinder vacuum cleaner Warning: If the red mark (Fig. 11/2) is
without an attached nozzle, there is a visible, use the cable retract button
greater risk of accidently vacuuming (Fig. 11/3) to draw in the cable again
up objects. up to the yellow mark (Fig. 11/1).
4. As illustrated, secure the nozzles no Otherwise the cable can break off.
longer required onto the accessories There is a risk of electric shock.
mount, as far as this is possible. 3. Switch on the cylinder vacuum cleaner
•Push the 2-in-1 combi-nozzle into the using the on/off switch (Fig. 11/4).
accessories mount (Fig. 10/a).
•Push the crevice nozzle onto the
accessories mount and attach it so it
clicks audibly and noticeably into
place(Fig. 10/b).
5. Keep the other nozzles safe and
inaccessible to children(Fig 10/b).
4. Adjust the carpet/hard floor switch (Fig.
12) depending on the type of flooring:
• Hard floor (Fig. 12/A) Laminate
flooring, tiles, PVC flooring, etc.
• Carpet (Fig. 12/B) Long and short pile
Operating the Unit carpets, runners, etc.
WARNING:
Check the cylinder vacuum cleaner
and the power cable before each use.
A damaged appliance must never be
used.
17