• H.E.P.A. filter (Fig. 3/5) Filters out the
fine particles from the blownout air.
Replace: every 6 months
Fig. 4/2
Cleaning the protective motor filter
Fig. 3/5 1. Switch the appliance off
2. Remove the dust container
• The filters can become blocked after 3. Release the filter cover (Fig. 4/3) and
some time and can thereby reduce the remove it.
suction power. It is therefore important 4. Remove the protective motor filter
that the abovementioned intervals are together with the holder at the lip
adhered to. provided for this purpose below right.
• If you determine that a filter is damaged
then replace it immediately.
Cleaning the Filters
• Switch the appliance off
• Remove and empty the dust container,
• Turn the separation unit anticlockwise Fig. 4/3
off the dust container (Fig. 4/1).
5. Hold the protective motor filter together
with the holder over a dustbin. Only
then should you separate both parts
from each other. For a rough clean,
Gently knock both parts over a dustbin.
Fig. 4/1 ATTENTION:
The protective motor filter is not suitable
• For a rough clean, hold the filter screen for the dishwasher.
over a dustbin. Then knock it gently.
If the filter screen is extremely dirty, NOTE:
rinse it thoroughly with a shower head If the protective motor filter is very dirty,
Fig. 4/2 Then leave it to dry completely. rinse it thoroughly with a shower head.
Only re-insert it once it is completely Do not use any brushes for this. Then
dry. leave the filter to dry (approx. 24 hours
at room temperature). Only use it again
when it is completely dry. If the dirt
17