Operating Instructions Mounting the accessories
Mounting suction hose • Crevice nozzle: Use this to vacuum
1. Plug the suction hose adapter into the dust from hard to reach places.
suction hose receiver and lock the
adapter by turning it clockwise to the
stop point.
ATTENTION:
If you use the cylinder vacuum cleaner
without an attached nozzle, there is a
2. Push the handle into the upper end of greater risk of accidently vacuuming
the telescopic tube. up objects.
Operating the Unit
WARNING:
Check the cylinder vacuum cleaner
and the power cable before each use.
3. Push the floor nozzle onto the lower A damaged appliance must never be
end of the telescopic tube. used.
ATTENTION:
Only use the cylinder vacuum cleaner
if all filters are correctly in place and
once you have ensured that no
openings are blocked The filters must
be intact and dry. Non-compliance can
4. Adjust the length of the telescopic tube. damage the cylinder vacuum cleaner.
To do this, press the telescopic tube
lock forwards. Then pull the telescopic 1. Push on the desired nozzle
tube by the handle to the desired 2. Remove the cable, by holding the plug,
length. To lock it, release the telescopic until the yellow mark is reached
tube lock while you pull. You will hear
an audible click. Warning: If the red mark is visible, use
the cable retract button to draw in the
■•• cable again up to the yellow mark
İN Otherwise the cable can break off.
There is a risk of electric shock.