a-
b-
c-
d-
Wall mounting
Drill two Ø 8 mm holes on the wall using
the paper template, insert two rawl plugs
and two 4.2x44,4 mm screws leaving 5 mm
untightened. Open the metal grille panel,
hood on and fully tighten the screws.
If the hood is not pprovided with a paper
fixing template, drill tow Ø 8 mm holes
(see draw), insert the plugs and sacrews,
proceeding as directed under
para-
graph a.
For wall mounting using walbrackets
(optional), follow the instructons of the fix-
ing template.
Pay attention to the safety regulation of
point 1.6.
b-
Internal recirculation mode TO check that
the hood is set up for recycling, open the
grille panel and make sure that the conver-
sion lever or the change-over knob on the
centrifugal unit is in the RECYCLING posi-
tion. The charcoal filter is to be fitted. To fit
the charcoal filter, support the filter with one
hand and turn the thumb screw through the
centre of the charcoal filter. If the filter is of
the interlocking type, turn the filter clock-
wise. The hood can remain connected to
the outside.
2.5.
Electrical connection and working test
- The safety measures 1.2, 1.3, 1.4 and 1.5
Of paragraph 1 are to be strictly observed.
2-
Once the electrical connection has been
completed, check that the worktop illumina-
tion, motor and speeds work properly.
2.4. Choice of operating mode
a- Evacuation mode To check that the hood is
set up for evacuation, open the gri le panel
and make sure that the conversion lever or
the change-over knob on the centrifugal
unit is in the DUCTING position. The char-
coal filter is not required.
For ducting to the outside, the hood is Sup-
plied with a rear and top outlet. A flange
spigot of 100 mm diameter (120 mm in
certain models) is usually fitted on the top
outlet and a blanking plug on the rear outlet.
If you choose to duct the hood from the rear
of the casing, yu should invert the position
of the flange and of the blanking plug. Pay
attention to the safety regulation 1 . 1