Hose Storage 6. Dirt Container & Fi lters: 3. When all the dirt has fallen, ciose the dirt
For conve ni ence there is a slot located an Rem ov al & R epla cement container flap and return the dirt container
either side of the vacuum cleaner next to the IMPORTANT: Always unplug the vacuurn ta the vacuurn cleaner.
carry handle where the floor tool can be cleaner from the electrical outlet before
parked for carrying and storage. removing the dirt container. Cleaning the central filler
1. Remove the dirt container as directed.
Carry Randle IMPORTANT: Do NOT use the vacuum deaner 2. Rotate the central filter and puIE away
Lise the carry handle located in the rniddle without ALL of the filters in place. from the dirt container.
of the vacuum deaner (inc. auto cord rewind 3. Gentlytap the filter against the side of a
button) to move from room to room. Emptyirıg the Dirt Contalner rubbish bin to remove excess dirt.
1. Press the button located on the dirt 4. The central filter can be washed in warm
S. Accessorles container handle ta pull out the dirt container in warm water (rnax 400 C). Aiiow to air
1. The accessori es can be attached directly (Fig.6/1) dry for 24 hours before replacing.
to the handle by removing the telescopic NOTE: Do NOT use any detergents or bosiling
tubes and pushing in the desired accessory. water to wash the Inter. Vax recommends
2. The accessori es can alsa be attached to washing the filter every time you empty the
the telescopic extension tube for ex-ira reach. dust container.
Remove the combination Floor head and 5. Return the central filter ta the dirt
push an the desired accessory. container and twist un-kil the filter issecure.
Crevice tool: for crevices, corners and cracks, 6. Return the dirt container to the vacuum
etc. deaner.
Turbo Brush: for pet heir and large carpeted
areas. (Note: Not recommended for hard 2. Holding the dirt container over a rubbish
floors). bin press the button on the side of the
2-in-1 Tool container to release diri (Fig.6/2)
Dusting brush: for delicate surfaces.
Upholstery took for carpet, upholstery, stairs,
etc.
Post-motor filter 8. Storage Cause: Dirt container not installecl properly.
NOTE: This is located on the right hand side IMPORTANT:Always unplug the vacuurn Solution: Reuiewdirt container replacement.
of the cleaner from the electrical outlet and rewind Cause: Dirt container fulf or blocked
vacuum cleaner. the power cord as directed before storirıg. SolutIon: Ernpty dirt container.
1. Release the port-motor cover by pressing NOM- Always store the vacuum cfeaner base Cause: Clogged f3lters.
in the catch at the top of the cover. down. Solution: Remove, clean and replace Nters,
2. Remove the filter by slidlng it to the left PROBLEM: Arressories won't pick up.
and pulling it out. 9. Troubleshooting Cause; Accessories are not attached correctly.
3. The post motor filler can be rinsed in warm WARNING; f o reduce the risk of personal Sahiden; Refer ta secuon 5.
water (rnax 400 Q. Allow to air dry for 24 ınjury, unplug the vacuum cfeaner before PROBLEM: Dust escaping from the vacuum
hours before replacing. performing maintenanceItroubfe shooting cleaner.
NOTE: Do NOT use any detergents or boifing checks. Cause: Ola container fulf,
water to wash the fifter. Vax recommends solution: Empty dirt container.
rinsing the filter every 9-12 months. PROBLEM: Vacuum cfeaner won't run cause: (»t container not ınstalfed correctly.
4. Re place the port-motor filler and cover Cause: Not properly pluggecl into e fectricaf solution: Revrew din container replacement
before restarting the vacuum cleaner. outlet. cause: Fılter not ınstalled completely.
Solution; Plug in securely. solution: Remove, clean and replace ışlters.
7. Cleaning Blockages Cause; No electricity In the electrical outlet.
WARNING: To reduce the risk of electric Sahiden: Check fuse or breaker.
shock, the power cord must be disconnected Cause; On/off switch not turned on.
be fare performing Solution: Push on/off switch to
maintenance/troubie shootıng checks. Cause; Motor thermostat has tripped.
1. Turn the vacuum cleaner off and unplug Solution: Switch affand unplug the vacuum
from the electrical outlet. cleaner.
2. The flexible hose can be disconnected from Leave for one (V hour before switchIng the
the vacuum cleaner by pushing in the buttons vacuum cleaner back on.
on the hose and pulling away from the Cause; elown fuseitripped breaker.
machine. Remove any blockages found then Solution: Reset circuit breaker or replace
reconnect the hose securely. fuse.
PROBLEM: Cfeaner won't pick up/loss of
suction.
10