For
•
DANGER:
The product must be connected to the mains
upply only by an authorised and qualified
person. The product's warranty period starts
ony after correct installation.
Manufacturer shall not be held responsible for
damages arising from procedures carried out
by unauthorised persons.
DANGER:
The power cable must not be clamped, bent
r trapped or come into contact with hot parts
of the product.
A damaged power cable must be replaced by
an Authorised Service Agent. Otherwise, there
is risk of electric shock, short circuit or fire!
Connection must comply with national regula-
tions.
The mains supply data must correspond to the
data specified on the b,tpe label of the product.
Open the front door to see the type label.
Power cable of your product must comply with
the values in 'Technical s 'fications" table.
oducts with cooli
fan
2
3
i
DANGER:
Before starting any work on the electrical
nsta iation, disconnect the product from the
ma•ns supply.
There is the risk of electric shock!
ower cable plug must be within easy reach
fier installation (do not route it above the
1 Cooling fan
2 Contro panel
3
Door
The built-in cooling fan cools both the built-in cabinet
and the front of the roduct.
Coo ing fan continues to operate for about 20-
0 minutes after the oven is switched off.
If you hava cooked by programming the timer
of the oven, coo ing fan will also be switched
off at the end of the cooking time together
with all functions.
Final check
I. Connect the power cable and switch on the
product's fuse.
2. Check the functions.
Future Transportation
Plug the power cable into the socket.
Installing the product
1. Slide the oven into the cabinet, align and secure it
while making sure that the power cable is not
broken and/or trapped.
Secure the oven with 2 screws as illustrated.
14/EN
•
•
Keep the product's original carton and transport
the product in it, Follow the instructions on the
carton, If you do not have the original carton,
pack the product in bubble wrap or thick card-
board and tape it securely.
To prevent the wire grill and tray inside the oven
from damaging the oven door, place a strip of
cardboard onto the inside of the oven door that
lines up with the position of the trays, Tape the
oven door to the side walls.
Do not use the door or handle to lift or move the
roduct.
i
i
Do not place any objects onto the product and
move it in upright position.
Check the general appearance of your product
or any damages that might have occurred
during transportation.